Microsoft Windows: Activate or start a sensor

Before you begin

  • Verify the sensor has been installed
  • Have experience working with the Microsoft Windows systems
  • Have admin permissions to activate the sensor
  • Have necessary permissions in CertCentral

See Discovery workflow and permissions.

Activate sensor

Use the start.bat command to activate and start the sensor. If the sensor is activated but not started, you can use the same commend to start the sensor.

  1. Go to the install_dir/cli.

    Where install_dir is the sensor installation directory.

  2. Run the start.bat command.

  3. When prompted, enter your CertCentral username and password.

  4. Select the division you want to assign the sensor to.

    If you don't have divisions, we return the name of the organization for your account.

What's next

You're ready to set up and run a scan using this sensor. See Set up and run a scan.