To configure automation on your sensor for an agentless appliance:
./addagentlessCLI command on the sensor and provide login credentials and other configuration settings to the sensor.
./addagentlessCLI command on the sensor and use a file to load login credentials and other configuration settings as a batch. See Configure sensor (agentless) automation settings using a file.
Log in to the sensor host.
Go to the sensor CLI directory.
Where install_dir is the installation directory for the sensor.
./addagentless.sh -type (BIGIP | NETSCALER | A10 | AWS)
addagentless.bat -type (BIGIP | NETSCALER | A10 | AWS)
Where -type specifies the type of appliance you want to configure.
When you enter the command, a series of prompts appears for each setting you need to enter. At each prompt, enter the specific settings for your appliance and press Return.
The information you enter for a load balancer varies depending on the load balancer type you configure (BIGIP, NETSCALER, A10, or AWS).
addagentless.bat -type A10
C:\Program Files\DigiCert\DigiCert sensor\cli>addagentless.bat -type A10 Sensor CLI. Copyright 2020, DigiCert Inc. Add or change login credentials and specify data IP addresses for certificate automation. Enter management IP address:10.141.17.192 Enter Management Port (443):443 If available, do you want to map this sensor with the previously voided loadbalancer (Y/N)?:N Important: Enter an account that has admin (superuser) permission to manage all partitions on the A10 load balancer. Enter admin username:admin Enter admin password: Confirm admin password: Successfully added or changed the agentless. IMPORTANT: After you run this command, return to Manage Automation Agents. Verify that the certificate host appears and is configured.
Verify the agentless automation configuration. See Verify sensor (agentless) automation configuration.