CertCentral
Link DigiCert® DNS with DigiCert CertCentral® to support automated DNS-based domain control validation (DCV). Configure the integration at the account level, then enable it for the primary zones you want to use.
Before you begin, confirm that you have permission to manage integrations in DigiCert® DNS and access to complete the corresponding setup in DigiCert CertCentral®. To enable the integration for a zone, the primary zone must already exist in DigiCert® DNS.
Integration status
The DigiCert CertCentral® controls and status indicate where you are in the integration lifecycle.
Display | Meaning | Next action |
|---|---|---|
Link available | The integration is not currently linked | Generate credentials to begin setup |
Pending activation | Setup has started, but activation is not complete | Complete the setup in DigiCert CertCentral® using the generated credentials |
Active | The integration is active | Review which zones have DigiCert CertCentral® enabled |
The Reset and Unlink controls are available after credentials have been generated, including while activation is pending.
If the integration remains Pending activation, verify that the DigiCert CertCentral®-side setup has been completed using the current credentials.
Link CertCentral
Begin by generating integration credentials in DigiCert® DNS, then complete setup in DigiCert CertCentral®.
To link DigiCert CertCentral®:
Open Integrations.
Beside Integrate CertCentral, select Link.
In Generate CertCentral credentials, select Generate.
In Save your credentials, select Copy.
The credentials are shown only once. Store them securely.
Select Continue.
Use the generated credentials to complete the integration in DigiCert CertCentral®.
Return to Integrations in DigiCert® DNS and confirm that the DigiCert CertCentral® status is Active before enabling the integration for a zone.
The generated credentials contain:
Credential | Description |
|---|---|
Account | The account identifier supplied for the integration |
Secret | The secret supplied to authenticate the integration |
These are integration credentials generated through the DigiCert CertCentral® linking workflow. For credentials used to access the DigiCert® DNS API, see DNS API tokens.
Reset CertCentral
Use Reset to generate replacement credentials. Resetting returns the integration to Pending activation. Update the configuration in DigiCert CertCentral® with the new credentials to reactivate it.
Open Integrations.
Beside Integrate CertCentral, select Reset.
In Reset CertCentral credentials, select Reset.
In Save your new credentials, select Copy.
The new credentials are shown only once. Store them securely.
Select Continue.
Update the configuration in DigiCert CertCentral® with the new credentials. Return to Integrations in DigiCert® DNS and confirm that the status is Active.
Unlink CertCentral
Unlinking disconnects the account from DigiCert CertCentral® and stops DNS-based validation automation provided by this integration. Review any processes that depend on the integration before proceeding.
Open Integrations.
Beside Integrate CertCentral, select Unlink.
Review the confirmation message.
Select Unlink to confirm.
Enable CertCentral for a zone
After the account-level integration is active, enable it for each primary zone that requires it:
Go to DNS > Zones and select Primary zones.
Open the zone.
Select Settings.
Turn on Enable CertCentral to enable the integration for the zone.
The CertCentral activated message confirms activation.
Disable CertCentral for a zone
Disabling the integration stops DNS-based validation automation for this zone. Review any processes that depend on the integration before proceeding.
Go to DNS > Zones and select Primary zones.
Open the zone.
Select Settings.
Turn off Enable CertCentral.
Review the Disable CertCentral dialog and confirm that it identifies the intended zone.
Select Disable.
Disabling DigiCert CertCentral® for a zone leaves the account-level integration linked. To disconnect the account, use Unlink on the Integrations page.