Automation
Go to Account > Settings > Automation to configure global settings for discovery tools and certificate lifecycle automation.
Let op
These settings are only available if the automation feature is enabled for your account. Contact your DigiCert account representative to verify or enable this feature.
Agent settings
Agent approval: Check the box to require manual approval when deploying new automation agents.
When this is enabled, any new agent you install and activate cannot be used for certificate automation until an administrator completes the manual agent approval process.
Blocked ports: Specify port numbers that should always be excluded from agent-based certificate automation.
Enter port numbers as a comma-separated list with hyphens for ranges. These ports are not available in the Configure IP/ports section of the agent details pages.
Changes here get applied daily across all agents. To apply changes immediately or to specific agents, select and configure each agent from the Discovery & automation tools > Agents page instead.
Windows and Linux agents have different blocked ports enabled by default. Use the Restore default function to restore either agent type to its default blocked ports list.
Belangrijk
Standaard voor agents geblokkeerde poorten:
Op Windows
Op Linux
System scan blocklist: Enter absolute paths of files, folders, or complete disk drives to exclude from system scanning for either Linux or Windows agents.
Enter the comma-separated absolute paths on the left, then select the Add to blocklist button.
Resources in the blocklist will be skipped for all subsequent system scan runs by any DigiCert agent.